Rosco Fluorescent - Special Effects Paint
 |
|
Click to enlarge image(s)
|
Available in 9 brighter than normal colors which fluoresce vividly under ultraviolet lights, Rosco Fluorescent paints can create a wide range of exciting effects. They can be used to create special effects using ultraviolet Blacklight or combined with other Rosco paints to make normal colors more vibrant. Fluorescents use the same high quality, water base, vinyl acrylic binder found in Off Broadway paints. It is suitable for use on most surfaces and for interior and exterior* applications. Try using Rosco Fluorescent paints when matching the brightest colors in the Pantone Color Matching System or to achieve astounding 3-D effects.
Click here to View Color Chart. Please note that the paint swatch samples shown on this Web site are th closest values displayed in Truecolor (24 bit). Your results may vary.
Download MSDS
|
* Fluorescent pigments will degrade from prolonged exposure to ultraviolet light. Avoid direct sunlight where possible. ** Invisible Blue is a milky white paint that fluoresces to a pale blue under blacklight. When painted over light colored surfaces, Invisible Blue is difficult to detect. However, it can be seen when painted over dark or black colors.
|
|
|
FINISH: Matte.
|
|
|
SOLVENT: Water.
|
|
|
BINDER TYPE: Vinyl Acrylic.
|
|
|
DILUTION: Fluorescent Paints should be used straight out of the can. They can be diluted with water if necessary, however this will reduce the hiding power of the paint.
|
|
|
SURFACE PREPARATION: Surfaces should be clean, dry and free from dirt and grease. Prime porous surfaces, except fabrics, using Rosco Tough Prime. If painting a new plaster surface, prime wall with a commercial primer/sealer designed for raw plaster. Then use Rosco Tough Prime as a final preparation. Use a white base coat to achieve the most dramatic color effects.
|
|
|
APPLICATION: Stir contents before use. Do not shake. Apply by brush, roller, or spray gun. Apply in thin uniform coats, using a good quality brush or roller. Use overlapping strokes, keeping a wet edge.
|
|
|
FILM THICKNESS: 2 mil. dry film.
|
|
|
COVERAGE: Approximately 300 sq. ft. per gallon.
|
|
|
AVG. DRY TIME: At 75°F (24°C). Dries to the touch in 30 minutes. Can be re-coated in 1-2 hours.
|
|
|
CLEAN-UP: Soap and water.
|
|
|
SHELF LIFE: Minimum 24 months.
|
|
|
All technical data, recommendations and service are accurate to the best of our knowledge. Rosco and Accenting Images assumes no responsibility for the results obtained or damage incurred from use by the buyer in whole or in part since method of application and its use is beyond our control.
|
|
